Bearing TSM 30 C ISB

Radial spherical plain bearings TSM 30 C

Bearing number : TSM 30 C

Size mm : 30x55x37

Brand : ISB

Bore Diameter mm : 30

Outer Diameter mm : 55

Width mm : 37

Bearing dimensions and specification in brand catalogue :

d - 30 mm

D - 55 mm

B - 37 mm

d1 - 34,8 mm

d2 - 70 mm

dk - 50,80 mm

h1 - 110 mm

l3 min. - 66 mm

l4 max. - 145 mm

r min. - 0,3 mm

C1 - 27 mm

Thread G - M30x2

Angle - 17 °

Weight - 1,07 Kg

Basic dynamic load rating C - 73 kN

Basic static load rating C0 - 77 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing TSM 30 C ISB number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing TSM 30 C ISB are designed to support only the weight of the Bearing TSM 30 C ISB, not the weight of the Bearing TSM 30 C ISB and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing TSM 30 C ISB, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing TSM 30 C ISB number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing TSM 30 C ISB are designed to support only the weight of the Bearing TSM 30 C ISB, not the weight of the Bearing TSM 30 C ISB and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing TSM 30 C ISB, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.