Bearing SAR1-12 NTN

Radial spherical plain bearings SAR1-12

Bearing number : SAR1-12

Size mm : 12x22x10

Brand : NTN

Bore Diameter mm : 12

Outer Diameter mm : 22

Width mm : 10

Bearing dimensions and specification in brand catalogue :

d - 12 mm

D - 22 mm

B - 10 mm

C - 7 mm

d1 - 15,3 mm

r1 min. - 0,6 mm

r2 min. - 0,6 mm

Angle - 10 °

Weight - 0,015 Kg

Basic dynamic load rating C - 11,4 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SAR1-12 NTN number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SAR1-12 NTN are designed to support only the weight of the Bearing SAR1-12 NTN, not the weight of the Bearing SAR1-12 NTN and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SAR1-12 NTN, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SAR1-12 NTN number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SAR1-12 NTN are designed to support only the weight of the Bearing SAR1-12 NTN, not the weight of the Bearing SAR1-12 NTN and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SAR1-12 NTN, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.