Bearing SIJK8C AST

Rod Ends / Metric - Steel on Steel, Steel on Bronze and Steel on PTFE / Female Series SIJK8C

Bearing number : SIJK8C

Brand : AST

Bore Diameter mm : 8

Width mm : 12

Bearing dimensions and specification in brand catalogue :

dimensions in mm

Bearing Type - steel-on-PTFE composite

Bore Dia d - 8.0000

Width B - 12.0000

Radius min rs - 0.300

Dynamic Load Rating Cr - 7,600

Static Load Rating Cor - 8,200

Spherical Diameter dk or Dk - 15.880

Mis-alignment Angle a deg. - 12

Thread Length l1 - 12.000

Bore Center to End of Rod h - 36.000

Rod Overall Length l2 - 48.000

Rod End Thickness C1 - 9.500

Bore Center to Body l7 - 13

Thread Size G - M8

Rod End Width d2 - 24.000

Body Dia. d3 - 12.500

Body End Dia. d4 - 16.000

Body End Width l5 - 5.000

Body End Flats W - 13.000

Weight g - 47.00

Material - Body - Carbon steel-zinc plated, Ball - Hardened chrome steel-chrome plated, Liner - PTFE composite material

Left-hand threads are available upon request.

Stainless steel is available upon request.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SIJK8C AST number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SIJK8C AST are designed to support only the weight of the Bearing SIJK8C AST, not the weight of the Bearing SIJK8C AST and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SIJK8C AST, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SIJK8C AST number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SIJK8C AST are designed to support only the weight of the Bearing SIJK8C AST, not the weight of the Bearing SIJK8C AST and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SIJK8C AST, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.