Bearing SBB 48-2RS IKO

Radial spherical plain bearings SBB 48-2RS

Bearing number : SBB 48-2RS

Size mm : 76.2x120.65x66.68

Brand : IKO

Bore Diameter mm : 76,2

Outer Diameter mm : 120,65

Width mm : 66,68

Bearing dimensions and specification in brand catalogue :

d - 76,2 mm

D - 120,65 mm

B - 66,68 mm

C - 57,15 mm

d1 - 86,5 mm

dk - 110 mm

ra max. - 0,6 mm

rb max. - 0,8 mm

Weight - 3,12 Kg

Basic dynamic load rating C - 616 kN

Basic static load rating C0 - 3700 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SBB 48-2RS IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SBB 48-2RS IKO are designed to support only the weight of the Bearing SBB 48-2RS IKO, not the weight of the Bearing SBB 48-2RS IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SBB 48-2RS IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SBB 48-2RS IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SBB 48-2RS IKO are designed to support only the weight of the Bearing SBB 48-2RS IKO, not the weight of the Bearing SBB 48-2RS IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SBB 48-2RS IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.