Bearing SB 120A IKO

Radial spherical plain bearings SB 120A

Bearing number : SB 120A

Size mm : 120x190x105

Brand : IKO

Bore Diameter mm : 120

Outer Diameter mm : 190

Width mm : 105

Bearing dimensions and specification in brand catalogue :

d - 120 mm

D - 190 mm

B - 105 mm

C - 90 mm

dk - 175 mm

r min. - 1 mm

da min. - 125,5 mm

da max - 140 mm

Da min - 184,5 mm

Da max. - 162 mm

Angle - 5 °

Weight - 12,4 Kg

Basic dynamic load rating C - 1540 kN

Basic static load rating C0 - 9270 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SB 120A IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SB 120A IKO are designed to support only the weight of the Bearing SB 120A IKO, not the weight of the Bearing SB 120A IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SB 120A IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SB 120A IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SB 120A IKO are designed to support only the weight of the Bearing SB 120A IKO, not the weight of the Bearing SB 120A IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SB 120A IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.