Bearing PHS 16EC IKO

Radial spherical plain bearings PHS 16EC

Bearing number : PHS 16EC

Brand : IKO

Bore Diameter mm : 16

Bearing dimensions and specification in brand catalogue :

d - 16 mm

L4 - 83 mm

L5 - 8 mm

dL - 27 mm

L3 - 33 mm

d1 - 19,4 mm

d2 - 38 mm

d3 - 22 mm

dk - 28,575 mm

h1 - 64 mm

r1 min. - 0,2 mm

B - 21 mm

C1 - 15 mm

W - 22 mm

Thread G - M16×2

Weight - 0,21 Kg

Basic dynamic load rating C - 42 kN

Basic static load rating C0 - 21,1 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing PHS 16EC IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing PHS 16EC IKO are designed to support only the weight of the Bearing PHS 16EC IKO, not the weight of the Bearing PHS 16EC IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing PHS 16EC IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing PHS 16EC IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing PHS 16EC IKO are designed to support only the weight of the Bearing PHS 16EC IKO, not the weight of the Bearing PHS 16EC IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing PHS 16EC IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.