Bearing SAR1-50SS NTN

Radial spherical plain bearings SAR1-50SS

Bearing number : SAR1-50SS

Size mm : 50x75x35

Brand : NTN

Bore Diameter mm : 50

Outer Diameter mm : 75

Width mm : 35

Bearing dimensions and specification in brand catalogue :

d - 50 mm

D - 75 mm

B - 35 mm

C - 28 mm

d1 - 56 mm

r1 min. - 0,6 mm

r2 min. - 1 mm

E - 68,4 mm

Angle - 6 °

Weight - 0,53 Kg

Basic dynamic load rating C - 124 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SAR1-50SS NTN number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SAR1-50SS NTN are designed to support only the weight of the Bearing SAR1-50SS NTN, not the weight of the Bearing SAR1-50SS NTN and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SAR1-50SS NTN, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SAR1-50SS NTN number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SAR1-50SS NTN are designed to support only the weight of the Bearing SAR1-50SS NTN, not the weight of the Bearing SAR1-50SS NTN and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SAR1-50SS NTN, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.