Bearing SA60ET-2RS LS

Radial spherical plain bearings SA60ET-2RS

Bearing number : SA60ET-2RS

Brand : LS

Bore Diameter mm : 60

Bearing dimensions and specification in brand catalogue :

d - 60 mm

B - 44 mm

d2 - 135 mm

dk - 80 mm

h - 210 mm

l1 min. - 115 mm

l2 max. - 277,5 mm

l7 min. - 75,5 mm

r min. - 1 mm

C1 max - 39 mm

Thread G - M52×3

Angle - 6 °

Weight - 5,7 Kg

Basic dynamic load rating C - 430 kN

Basic static load rating C0 - 450 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SA60ET-2RS LS number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SA60ET-2RS LS are designed to support only the weight of the Bearing SA60ET-2RS LS, not the weight of the Bearing SA60ET-2RS LS and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SA60ET-2RS LS, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing SA60ET-2RS LS number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing SA60ET-2RS LS are designed to support only the weight of the Bearing SA60ET-2RS LS, not the weight of the Bearing SA60ET-2RS LS and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing SA60ET-2RS LS, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.