Bearing PB 30 IKO

Radial spherical plain bearings PB 30

Bearing number : PB 30

Size mm : 30x66x37

Brand : IKO

Bore Diameter mm : 30

Outer Diameter mm : 66

Width mm : 37

Bearing dimensions and specification in brand catalogue :

d - 30 mm

D - 66 mm

B - 37 mm

C - 25 mm

d1 - 34,8 mm

dk - 50,8 mm

r min. - 0,6 mm

Weight - 0,61 Kg

Basic dynamic load rating C - 62,3 kN

Basic static load rating C0 - 149 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing PB 30 IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing PB 30 IKO are designed to support only the weight of the Bearing PB 30 IKO, not the weight of the Bearing PB 30 IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing PB 30 IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing PB 30 IKO number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing PB 30 IKO are designed to support only the weight of the Bearing PB 30 IKO, not the weight of the Bearing PB 30 IKO and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing PB 30 IKO, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.