Bearing GW 280 CX

Radial spherical plain bearings GW 280

Bearing number : GW 280

Size mm : 280x460x110

Brand : CX

Bore Diameter mm : 280

Outer Diameter mm : 460

Width mm : 110

Bearing dimensions and specification in brand catalogue :

d - 280 mm

D - 460 mm

H - 110 mm

a - 80 mm

d1 - 337 mm

B - 100 mm

C - 85 mm

D1 - 445 mm

D2 - 366 mm

R - 480 mm

Angle - 4 °

Weight - 84 Kg

Basic dynamic load rating C - 11400 kN

Basic static load rating C0 - 17000 kN

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing GW 280 CX number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing GW 280 CX are designed to support only the weight of the Bearing GW 280 CX, not the weight of the Bearing GW 280 CX and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing GW 280 CX, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.

Wherever possible, damage should be recorded, photographed and witnessed.Report any damage to the carriers and Pioneer Machinery as soon as possible, quoting the Bearing GW 280 CX number and consignment note reference. The insurance company’s agents shown on the insurance certificate should also be advise. Eyebolts and/or lifting trunnions supplied with the Bearing GW 280 CX are designed to support only the weight of the Bearing GW 280 CX, not the weight of the Bearing GW 280 CX and any ancillary equipment attached to it. Be absolutely sure that cranes, jacks, slings and lifting beams are capable of carrying the weight of equipment to be lifted. Where an eyebolt is provided with the Bearing GW 280 CX, this should be screwed down until its shoulder is firmly against the face of the stator frame to be lifted. Eyebolts are normally designed for a vertical lift. For eyebolt/lifting lug torques, see opposite.